CDP-CE575
SECTION 5
TEST MODE
ADJ MODEConnecting Location:
NOTE: This mode cannot be performed without a general remote com-� MAIN BOARD (Component Side) �
mander.
1. Chuck the CD first, and then turn OFF the power.
2. Short-circuit the test point TP (ADJ) of the MAIN board and
ground with a lead wire.
3. Press the [POWER] button to turn ON the power.
The CD is playback the 2nd track automatically and the ADJ
mode is set.
4. To exit the mode, pr[POWER]ess the button to turn OFF the
power.
ADJ Mode Special Function Table
ButtonFunction
DISC 1RFDC display
DISC 2Decision of Disc size (8/12 cm)
DISC 3Change the slice level
DISC 4Change the focus bias (high/middle/low)
DISC 5Track jump (1st y 20th)
TIME/TEXTTRK off/on
MOffset (VC), EF bias display
mOffset (RF, FE, TRK) display
EX-CHANGE Focus bias down
DISK SKIPFocus bias up
X-FADETrack gain up/down
EDITDisc kind (aluminum/RW), side (8/12 cm) display
CHECKS-curve mode
CLEARRFCK t GFS t error rate display
PEAK SERCH Best point of focus bias, jitter value display
FADERAuto gain display
TP (AFADJ)
FLUORESCENT INDICATOR TUBE, LED ALL LIT,
AND KEY CHECK MODER301
1. Short-circuit the test TP (AFADJ) of the MAIN board andTP (ADJ)
ground with a lead wire.
2. Press the [POWER] button to turn ON the power.
The whole fluorescent indicator tube lights up.
3. All buttons have individual button numbers.
When a button is pressed, the button number is counted up
and displayed.
10
button numberDisplays button number
When remote controller signals are recei**� will beved, ORM
displayed.
(** are the numbers corresponding to the remote controller
buttons)
When using the remote controller[CD1/2/3], switch the switch
to CD1.
4. To exit the mode, pr[POWER]ess the button to turn OFF the
power.
14 |
ACEC
