SECTION 5
MECHANICAL ADJUSTMENT
Y Elevator Height (Address) Adjustment
Note:This adjustments is necessary when the system controller (IC201),Adjustment Method:
variable resistor (RV201), slider (R), slider (L),1. or cConnect this set to the master unit (e.g. XR-C5300X), load ahassis (ELV)
was replaced for any repair.disc magazine, and place the set vertically as shown below.
Connection:2. Connect the regulated power supply to the master unit, and
power supplyturn the power on.
(DC 14.4 V)
3. Press the DISC button on the master unit and select DISC 5.
master unit
4. At this time, if the elevator shaft does not position between+
GND
comb teeth A and B at addresses 5 and 6 as shown below,
adjust the following.
5. Press repeatedly the DISC + and � buttons on the master unit
so that the elevator shafts moves from address 6 to address 5,
or from 5 to 6. At this time, adjust RV201 on the main board
BUS cable
so that the elevator shaft positions smoothly between comb
teeth A and B.
6. Further, place the set horizontally and make same adjustment
as mentioned above.
7. After adjustment at addresses 5 to 6 is finished, check all op-
erations from addresses 1 to 10 with the set placed vertically
and horizontally respectively to confirm that the elevator shaft
positions in a range between comb teeth A to B.compact disc changer
CONTROL connector
(CN901)
comb tooth at address 6comb tooth at address 6
elevator shaft
AA
elevator shaft
BB
comb tooth at address 5
comb tooth at address 5
OKNG
RV201
13 |
ACEC
