Cleaning the connectors
The unit may not function properly if theDismounting the unit
connectors between the unit and the front
panel are not clean. In order to prevent this,
1Press the clip inside the front cover with
open the front panel by pressing (OPEN), then
a thin screwdriver, and gently pry the
detach it and clean the connectors with a
front cover free.
cotton swab dipped in alcohol. Do not apply
too much force. Otherwise, the connectors may
be damaged.
2Repeat step 1 on the left side.
The front cover is removed.
Main unit
Back of the front panel
Notes
3Use a thin screwdriver to push in the clip
YFor safety, turn off the engine before cleaning
on the left side of the unit, then pull out
the connectors, and remove the key from the
ignition switch.the left side of the unit until the catch
YNever touch the connectors directly with yourclears the mounting.
fingers or with any metal device.
4Repeat step 3 on the right side.
5Slide the unit out of the mounting.
25 |