3-227-643-11 (1)
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
23 watts per channel minimum continuous average power into
4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than
5 % total harmonic distortion.
CD player sectionPower amplifier sectionFM/AM
Signal-to-noise ratio90 dBOutputsSpeaker outputs
Frequency response10 20,000 Hz(sure seal connectors)
Wow and flutterBelow measurable limitSpeaker impedance4 8 ohmsCompact Disc
Laser Diode PropertiesMaximum power output 50 W � 4 (at 4 ohms)
MaterialGaAlAs
Wavelength780 nm
General
Emission DurationContinuousPlayer
Laser output powerLess than 44.6 W*OutputsAudio output
Power amplifier control
*This output is the value measured at a distance of
Power antenna relay control
200 mm from the objective lens surface on the
Tone controlsBass 10 dB at 20 Hz
Optical Pick-up Block.
Treble 10 dB at 20 kHz
Operating InstructionsPower requirements12 V DC car battery
Tuner section(negative earth)
DimensionsApprox. 178 � 50 � 176 mm
FM1
(7 /8 � 2 � 7 in.)
Tuning range87.5 107.9 MHz
(w/h/d)
Antenna terminalExternal antenna connectorMounting dimensionsApprox. 182 � 53 � 161 mm
Intermediate frequency10.7 MHz113
(7 /4 � 2 /8 � 6 /8 in.)
Usable sensitivity11 dBf
(w/h/d)
Selectivity75 dB at 400 kHz
MassApprox. 1.2 kg (2 lb. 10 oz.)
Signal-to-noise ratio65 dB (stereo),
Supplied accessoryParts for installation and
68 dB (mono)
connections (1 set)
Harmonic distortion at 1 kHz
Front panel case (1)
0.7 % (stereo),
Card remote commander
0.5 % (mono)
RM-X115
Separation33 dB at 1 kHz
Frequency response30 15,000 Hz
OwnerOs Record
AMDesign and specifications are subject to changeThe model and serial numbers are located on the bottom of the unit.
Tuning range530 1,710 kHzwithout notice.Record the serial number in the space provided below.
Antenna terminalExternal antenna connectorRefer to these numbers whenever you call upon your Sony dealer regarding this
Intermediate frequency10.7 MHz/450 kHzproduct.
Sensitivity30 V
Model No. CDX-L350 Serial No.
For installation and connections, see the supplied installation/connections
manual.
Getting Started
CDX-L350
Sony Corporationé2001Printed in Korea
Attaching the front panel
Resetting the unitAttach part A of the front panel to part B of the
unit as illustrated and push the left side into
Before operating the unit for the first time or
position until it clicks.
after replacing the car battery, you must reset
the unit.
Press the RESET button with a pointed object,WarningWelcome !
such as a ball-point pen.
This equipment has been tested and found toThank you for purchasing this Sony Compact
comply with the limits for a Class B digitalDisc Player. You can enjoy its various features
device, pursuant to Part 15 of the FCC Rules.even more with:
These limits are designed to provide reasonable
YSupplied controller accessory
protection against harmful interference in a
ACard remote commander RM-X115
residential installation. This equipment
B
RESET buttongenerates, uses, and can radiate radio frequency
energy and, if not installed and used in
Noteaccordance with the instructions, may cause
Pressing the RESET button will erase the clockharmful interference to radio communications.
setting and some stored contents.However, there is no guarantee that interference
will not occur in a particular installation. If this
Note
equipment does cause harmful interference to
Do not put anything on the inner surface of the
radio or television reception, which can be
front panel.
determined by turning the equipment off and
Detaching the front panel
on, the user is encouraged to try to correct the
interference by one or more of the following
You can detach the front panel of this unit to
measures:
protect the unit from being stolen.
N Reorient or relocate the receiving antenna.
Setting the clock
N Increase the separation between the
Caution alarmequipment and receiver.
The clock uses a 12-hour digital indication.
If you turn the ignition switch to the OFFN Connect the equipment into an outlet on a
position without removing the front panel, theExample: To set the clock to 10:08circuit different from that to which the
caution alarm will beep for a few seconds.receiver is connected.
1Press (DSPL) for 2 seconds.N Consult the dealer or an experienced radio/
The hour indication flashes.TV technician for help.
1Press (OFF)*.
CD playback or radio reception stops (the
You are cautioned that any changes or
key illumination and display remain on).
modifications not expressly approved in this
*If your car has no ACC position on the ignitionmanual could void your authority to operate
switch, be sure to turn the unit off by pressing1 Press either side of the volume +/�this equipment.
(OFF) for 2 seconds to avoid car battery drain.button to set the hour.
2Press (RELEASE), then pull it off towardsCAUTION2 Press (SEL).
you.The minute indication flashes.
(OFF)The use of optical instruments with this product
3 Press either side of the volume +/�will increase eye hazard.
button to set the minute.
2 Press (DSPL).
(RELEASE)
NotesThe clock starts. After the clock setting is
YIf you detach the panel while the unit is stillcompleted, the display returns to normal
turned on, the power will turn off automatically toplay mode.
prevent the speakers from being damaged.
YDo not drop or put excessive pressure on the front
panel and its display window.
YDo not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in
parked cars or on dashboards/rear trays.
Tip
When carrying the front panel with you, use the
supplied front panel case. |
ACEC
