CDX-S2000/S2000S/SW200
Notes on CD-Rs (recordable CDs)/CD-RWs (rewritablez UNLEADED SOLDER
CDs)Boards requiring use of unleaded solder are printed with the lead
This unit can play the following discs:free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
Type of discsLabel on the discthe lead free mark due to their particular size.)
: LEAD FREE MARK
Audio CD
Unleaded solder has the following characteristics.
Y Unleaded solder melts at a temperature about 40!C higher than
ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350!C.
MP3 filesCaution: The printed pattern (copper foil) may peel away if the
heated tip is applied for too long, so be careful!
YStrong viscosity
Unleaded solder is more viscous (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
YUsable with ordinary solder
? Some CD-Rs/CD-RWs (depending on the equipment used for
It is best to use only unleaded solder but unleaded solder may
its recording or the condition of the disc) may not play on this
also be added to ordinary solder.
unit.
?
? You cannot play a CD-R/CD-RW that is not f.inalized
? You can play MP3 files recorded on CD-ROMs, CD-Rs, and
CD-RWs.
? A CD-R/CD-RW to which a session can be added can be played.
? A process necessary for a recorded CD-R/CD-RW disc to be
played on the audio CD player.
EXTENSION CABLE AND SERVICE POSITION
When repairing or servicing this set, connect the jig (extension cable)
as shown below.
YConnect the MAIN board (CN751) and the SERVO board (CN1)
with the extension cable (Part No. J-2502-076-1).
MAIN BOARD
J-2502-076-1
CN751
SERVO BOAR D
CN1
3 |
ACEC
