Capsule Black AssyCapsule Comple Pwb, Capsule Base Assy
Capsule cushion
Capsule
MA-109 board
complete pwb
Red lead
Capsule base assy
White lead
Caution:
Precision
. When reinstalling the white and red leads,
+K 1.4x3 (three)Terminal
slack off the leads as shown above and be
sure not to come in contact with each other
and the inside of the capsule cushion.
. After soldering the leads, apply bond (SC608-LUZ) Unfasten the three +K 1.4x3 screws and remove the
to the parts circled with a dotted line in the capsule complete pwb. Pull out the terminal of the
illustration to keep the leads from breaking.capsule base assy with tweezers.
Red lead
White lead
White lead
Lug
Special screw
Capsule
M 1.2x3
complete pwb
Capsule cushion
Q01
Capsule base assy
Base screen
Terminal
Remove the base screen and the terminal. Unfasten
the M 1.2x3 screw and remove the lug. When removing
the white lead, apply toluene to the white lead and the
inside of the capsule base assy and remove the lead.
Capsule block assy
When reinstalling the white lead, apply a little of Sony
Bond Master to it.
Chasis
Precision
+K 2x3 (two)
Unfasten the two +K 2x3 screws and remove
the capsule block assy from the chassis.
(Torque: 1.4 kgfácm)
4-2CU-F780/G780/E700/E672/F117 |
ACEC
