Getting StartedGetting Started
Parts and Controls
FrontRear
1 (RESET) button (pages 7 and 11)5 > (CONTRAST) ?// buttons (page 6)
Resets the adjustments to the factory settings.Adjust the contrast.
Operate as the ?// buttons when adjusting other items.
2 (AUTO SIZING AND CENTERING) buttonEN
(page 6)6 u (POWER) switch and indicator (page 12)
Automatically adjusts the size and centering of theTurns the monitor on and off.F
images.The indicator lights up green when the monitor is on,
and lights up orange when the monitor is in Power
ES3 ? (BRIGHTNESS) ./> buttons (page 6)
Saving mode.
Adjust the picture brightness.
Operate as the ./> buttons when adjusting otherD7 AC IN connector
items.Provides AC power to the monitor.
J
4 (MENU) button (page 7)8 Video input 1 connector (HD15)
Inputs RGB video signals and SYNC signalsC sDisplays the MENU OSD.
9 Video input 2 connector (5 BNC)
C t
Inputs RGB video signals (0.7 Vp-p, positive) and SYNC
signals.
PL
GENERAL
SECTION 1
Use of the Tilt/SwivelVideo Input 1 Connector (HD15)
With the tilt/swivel, you can adjust this monitor to any desired
angle within 180! horizontally and 20! vertically.
To turn the monitor vertically and horizontally, hold it at the5 4 3 2 1
bottom with both hands as shown below.10 9 8 7 6
15 14 13 12 11
15!
90!Pin No.SignalPin No.Signal
1Red8Blue Ground
90!
2Green (Composite9DDC +5V*
Sync on Green)10Ground
5!
3Blue11ID (ground)
4ID (ground)12SDA (serial data)
5DDC Ground*13Horizontal Sync
6Red Ground14Vertical Sync
7Green Ground15SCL (serial clock)
* Display Data Channel (DDC) standard of VESA.
5
The operating instructions mentioned here are partial abstracts from the Operating Instruction Manual. The page numbers of the Operating Instruction Manual remain as in the manual.
� 5 � |
ACEC
