DCR-DVD100/DVD100E
COVERCOVER
1-4. COLOR ELECTRONIC VIEWFINDER SYSTEM
ADJUSTMENT
Note1: When replacing the LCD unit, be careful to prevent damages
caused by static electricity.
Note2: Before performing the adjustments, check the data of page: 0,
address: 10 is O00�. If not, set data: 00 to this address.
Note3: As the PANEL CLOSE switch is attached to the cabinet (R), this
cabinet must be attached when performing adjustments.
If you perform the adjustments with cabinet (R) removed, set the
following data.
1) Select page: 3, address: 00, and set data: 00.
2) Select page: 3, address: 02, set data: 02, and press PAUSE button.
Reset the data after completing adjustment.
1) Select page: 3, address: 00, and set data: 00.Remove the CPC lid (bottom).
2) Select page: 3, address: 02, set data: 00, and press PAUSE button.
Note4: NTSC model: DCR-DVD100
PAL model: DCR-DVD100E
Switch setting:
LCD panel .................................................................... Closed
[Adjusting connector]
Most of the measuring points for adjusting the viewfinder system
are concentrated in CN1003 of VC-307 board.
Connect the Measuring Instruments via the CPC-8 jig (J-6082-388-
A).
The following table shows the Pin No. and signal name of CN1003.
Pin No.
191
Pin No.Signal NamePin No.Signal Name
1GND2GND
3PANEL VG4H START202
5XHD/PSIG6EVF VG
7EVF VCO8EVF BL
9D 3.1V10LANC SIG
11MS XIN12MS DIO
Fig. 6-1-14.13MS BS14MS VCC ON
15MS SCLK16ACCESS LED
17C PIO518C PIO4
19S TXD20S RXD
Table 6-1-10.
6-27 |
ACEC
