Connecting your camcorder to your computer � Introduction
7Click [Finish].For Microsoft Windows 2000
users
The connection between your
camcorder and the computer is1Connect the AC adaptor to your
completed.camcorder.
2Set the mode dial to (Play/Edit).
To confirm the USB driver installation3Turn the power on your camcorder by
1 Click [Start] t [Control Panel].pressing the POWER button for a few
2 Click [Performance and Maintenance]seconds.
t [System].
[System Properties] window appears.4Connect the (USB) jacks of the
3 Click [Hardware] tab.camcorder and the (USB) port of the
computer using the USB cable supplied
4 Click [Device Manager].with your camcorder.
[Device Manager] window appears.Viewing/duplicating discs/editing the recordings on your computer
5 Make sure that [SONY DDX-A1010 USB
Device] appears in DVD/CD-ROM
drives, [Generic volume] in StorageUSB port
volumes, and [USB Mass Storage
Device] in [Universal Serial Bus
controllers] respectively.
When all the devices appear, the USB
driver is installed correctly. If any ofUSB cable
these devices are not shown, install the(supplied)
USB driver again following OIf you
cannot install the USB driver� (page 98).
USB jack
Your computer recognizes the
camcorder, and the [Found New
Hardware] dialog box appears.
5Follow the instructions given in the on-
screen messages.
The connection between your
camcorder and the computer is
completed.
95 |
ACEC
