DCR-PC101/PC101E
4-3. SERVICE MODE2. Emergence Memory Address
Additional note on adjustment2-1.C Page Emergence Memory Address
Note:After the completion of the all adjustments, cancel the ser-
Page CAddress F4 to FF
vice mode by either of the following ways.
1) After data on page: D is restored, press the RESET
button to reset the unit. (In this case, date and time andAddressContents
menu setting have been set by users are canceled. Per-
F4EMG code when first error occurs
form resetting)
Upper: MSW code when shift starts when first error
2) After data on page: D is restored, select page: 0, ad-
F6occurs
dress: 01, and return the data to 00. And when data on
Lower: MSW code when first error occurs
page: 2 and 3 are changed, return data to the original
condition.Lower: MSW code to be moved when first error
F7
occurs
1. Setting the Test Mode
F8EMG code when second error occurs
Upper: MSW code when shift starts when second
Page DAddress 10
FAerror occurs
Lower: MSW code when second error occurs
DataFunction
Lower: MSW code to be moved when second error
FB
00Normaloccurs
01Forced camera power ONFCEMG code when last error occurs
02Forced VTR power ONUpper: MSW code when shift starts when last error
FEoccurs
03Forced camera + VTR power ON
Lower: MSW code when last error occurs
05Forced memory power ON
Lower: MSW code to be moved when last error
FF
occurs
Y Before setting the data , select page: 0, address: 01, and set data:
01.
When no error occurs in this unit, daO00� is written in the abota ve
Y For page D, the data set will be recorded in the non-volatile
addresses (F4 to FF). when first error occurs in the unit, the data
memory by pressing the PAUSE button of the adjustment re-
corresponding to the error is written in the first emergency ad-
mote commander. In this case, take note that the test mode will
dress (F4 to F7). In the same way, when the second error occurs,
not be exited even when the main power is turned off (8.4 Vdc).
the data corresponding to the error is written in the second emer-
Y After completing adjustments/repairs, be sure to return the data
gency address (F8 to FB).
of this address to 00, and press the PAUSE button of the adjust-
Finally, when the last error occurs, the data corresponding to the
ment remote commander. And select page: 0, address: 01, and
error is written in the last emergency address (FC to FF).
set data: 00.
Note:After completing adjustments, be sure to initialize the data
of addresses F4 to FF to O00�.
Initializing method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 3, address: 01, set data: 37, and press the PAUSE
button.
3) Select page: 0, address: 01, and set data: 00.
5-61 |
ACEC
