DCR-PC115/PC115E/PC120BT/PC120E
6. Flange Back AdjustmentRadarWRadarWRadarWRadarWRadarW
(Using Minipattern Box)
The inner focus lens flange back adjustment is carried outAdjusting method:
automatically. In whichever case, the focus will be deviated during
Order Page Address DataProcedure
auto focusing/manual focusing.100101Set the data.
SubjectSiemens star chart with ND filter for
260113 Set the data, and press PAUSE button.
the minipattern box (Note 1)
360127 Set the data, and press PAUSE button.
Measurement PointDisplay data of page: F, address: 59
Measuring Instrument Adjustment remote commander4602Check that the data changes to
O01�. (Note 4)
Adjustment PageF
5F59Check that the data is O00� to O0E�.
Adjustment Address40 to 45, 50 to 59
Specified Value00 to 0ENote 4:The adjustment data will be automatically input to page: F, address:
40 to 45, 50 to 59.
Note 1:Dark Siemens star chart.
Note 2:Check that the data of page: 6, address: 02 is O00�. If not, to page:Processing after Completing Adjustments:
6, address: 01, set data: 00, and press the PAUSE button.
Order Page Address DataProcedure
Note 3:This adjustment should be carried out upon completion of the
following adjustments.160100 Set the data, and press PAUSE button.
HALL adjustment200100Set the data.
MR adjustment
3Perform OFlange Back Check�.
Switch setting:
1) POWER.................................................................. CAMERA
2) NIGHT SHOT ..................................................................OFF
Preparations:
1) The minipattern box is installed as shown in the following
figure.
Note:The attachment lenses are not used.
2) Install the minipattern box so that the distance between it and
the front of the lens of the camcorder is less than 3cm.
3) Make the height of the minipattern box and the camcorder equal.
4) Check that the output voltage of the regulated power supply is
the specified voltage.
5) Check that at both the zoom lens TELE end and WIDE end,
the center of the Siemens star chart and center of the exposure
screen coincide.
Specified voltage: The specified voltage varies according to the
minipattern box, so adjust the power supply
output voltage to the specified voltage written
on the sheet which is supplied with the
minipattern box.
Below 3 cm
Minipattern box
Camcorder
Camera
table
Regulated power supply
Output voltage : Specified v?0.01Vdcoltage
Output current : more than 3.5A
Red (+)
Black (�)
Yellow (SENS +)
White (SENS �)Need not connected
Black (GND)
Fig. 5-1-10.
5-24 |
ACEC
