1-2-2. INITIALIZATION OF B PAGE DATAProcessing after Completing Modification of B Page data:
(DCR-PC5/PC5E)Order Page Address DataProcedure
Note:When reading the B page data, insert a OMemory Stick� into the
OMemory Stick� slot.120029Set the data.
Switch setting:220129Set the data, and press PAUSE
POWER.................................................................button.MEMORY
1. Initializing the B Page Data3. B Page Table
Note:If the B page data has been initialized, the following adjustments
need to be performed again.Note:Fixed data-1: Initialized data. (Refer to O1. Initializing the B Page
1) Modification of B page dataData�.)
Fixed data-2: Modified data. (Refer to O2. Modification of B Page
Adjusting pageBData�.)
Adjusting Address00 to FFAddressRemark
Initializing Method:00 to 13Fixed data-1
Order Page Address DataProcedure14Fixed data-2
100101Set the data.15(Modified data. Copy the data built in the same
228F02Set the data, and press PAUSE16model.)
button.17
328F03Set the data, and press PAUSE18
button.19
428F02Set the data, and press PAUSE1A to 4FFixed data-1
button.50Fixed data-2
528F00Set the data, and press PAUSE51 to 53Fixed data-1
button.54Fixed data-2
650E00Set the data, and press PAUSE55 to 6FFixed data-1
button.70Fixed data-2
7501F3Set the data, and press PAUSE71 to FFFixed data-1
button.Table. 5-1-5.
850001Set the data, and press PAUSE
button.
950ECheck that the data changes to
O01�.
10Perform OModification of B
Page Data�.
2. Modification of B Page Data
If the B page data has been initialized, change the data of the OFixed
data-2� address shown in the following tables by manual input.
Preparations:
Order Page Address DataProcedure
128F02Set the data, and press PAUSE
button.
228F03Set the data, and press PAUSE
button.
328F02Set the data, and press PAUSE
button.
428F00Set the data, and press PAUSE
button.
Modifying Method:
1) Before changing the data, select page: 0, address: 01, and set
data: 01.
2) New data for changing are not shown in the tables because
they are different in destination. When changing the data, copy
the data built in the same model.
Note:If copy the data built in the different model, the camcorder may
not operate.
3) When changing the data, press the PAUSE button of the
adjustment remote commander each time when setting new
data to write the data in the non-volatile memory.
5-12 |
ACEC
