2-11.LCD HINGE ASSEMBLY, PR-037, PO-007 BOARDS
(Remove the LCD unit referring to section 2-1 before starting disassembling.)
6 Hinge cover (rear)
4 Screw (M1.7 � 2.5)
5 Two claws
3 Blind plate assembly,
PO-007 board7 Claw
1 Screw
(M1.7 � 2.5)
8 Hinge cover (front)
9
2 Tapping
screw
(M1.7 � 5)
4 LCD hinge assembly
4 Blind plate
3 Two claws
assembly
2 PD-113 harness
6 PO-007 board
5 Two solderings
2 PR-037 board
1 PR-063 harness
3 PR-037 board
1 Two solderings
7 PR-063 harness
SOLDERING OF HARNESS (PR-063)
Soldering position1 Connect the black harness at the leftmost end of the
harness (PR-063) and connect the second gray harness
PR-037 board (PR-063) to the PR-037 board by soldering.
PO-007 board
Boss hole
PR-037 board2 Check that there is no cold soldering, non-soldering,
solder slump nor solder bridge.
HarnessHarness
Note: Align the direction of the harA as shoness wn in the
(black)(gray)
picture.
Be careful that the harness must not be caught by the
boss hole.
3 Connect the third black harness and the fourth gray harness
from the leftmost end of the PO-007 board by soldering.
HarnessHarness
(gray)
(black)4 Check that there is no cold soldering, non-soldering, solder
Harness slump nor solder bridge.
HarnessPO-007 board
(gray)
(black)
Note:Align the direction of the har A as shoness wn in the
picture.
Boss hole Be careful that the harness must not be caught by the
boss hole.
HarnessHarness
Specification
(black)(gray)
Reference of counting the harness starts counting from the
black harness in the end.
A PR-063 harness
2-9 |
ACEC
