2-2. F Page Emergence Memory Address2-3. EMG Code (Emergency Code)
Note 1:Emergence of PB mode only.Codes corresponding to the errors which occur are written in C
page, addresses F4, F8 and FC (or F page, addresses 10, 14 and 18).
Page FAddress 10 to 1BThe type of error indicated by the code are shown in the following
table.
CodeEmergency Type
AddressContents
00No error
10EMG code when first error occurs
10Loading motor emergency during loading12Upper: MSW code when shift starts when first error
occurs11Loading motor emergency during unloading
Lower: MSW code when first error occurs22T reel emergency during normal rotation
13Lower: MSW code to be moved when first error
23S reel emergency during normal rotation
occurs
T reel emergency (Short circuit between S reel
14EMG code when second error occurs24
terminal and T reel terminal)
16Upper: MSW code when shift starts when second
30FG emergency at the start up of the capstan
error occurs
40FG emergency at the start up of the drum
Lower: MSW code when second error occurs
42FG emergency during normal rotation of the drum17Lower: MSW code to be moved when second error
occurs
18EMG code when last error occurs
1AUpper: MSW code when shift starts when last error
occurs
Lower: MSW code when last error occurs
1BLower: MSW code to be moved when last error
occurs
When no error occurs in this unit, daO00� is written in the abota ve
addresses (10 to 1B). when first error occurs in the unit, the data
corresponding to the error is written in the first emergency address
(10 to 13). In the same way, when the second error occurs, the data
corresponding to the error is written in the second emergency address
(14 to 17).
Finally, when the last error occurs, the data corresponding to the
error is written in the last emergency address (18 to 1B).
Note 2:After completing adjustments, be sure to initialize the data
of addresses 10 to 1B to O00�.
Initializing method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: F, address: 10, set data: 00, and press the PAUSE
button.
3) Select address: 11 to 1B and set data O00� into them in the
same way as in address: 10.
4) Select page: 0, address: 01, and set data: 00.
5-58 |
ACEC
