2-2. DIGITAL8 MODE2-2-3. OVERALL TAPE PATH CHECK
2-2-1. HOW TO ENTER RECORD MODE WITHOUT
CASSETTE1. Recording of the tape path check signal
1) Clean the tape running side (tape guide, capstan shaft, pinch
1) Connect the adjustment remote commander to the LANC jack.roller).
2) Turn the HOLD switch of the adjustment remote commander2) Connect the adjustment remote commander to the LANC jack.
to the ON position.3) Turn the HOLD switch of the adjustment remote commander
3) Close the cassette compartment without the cassette.to the ON position.
4) Select page: 3, address: 01, and set data: 0C, and press the4) Set to the camera recording mode.
PAUSE button of the adjustment remote commander5). Select page: 3, address: 1C, set data: 5D, and press the PAUSE
(The mechanism enters the record mode automatically)button of the adjustment remote commander.
Note: The function buttons becomes inoperable.6) Record for several minutes.
5) To quit the record mode, select page: 3, address: 01, set data:7) Release the camera recording mode.
00, and press the PAUSE button of the adjustment remote com-8) Select page: 3, address: 1C, set data: 00, and press the PAUSE
mander. (Whenever you want to quit the record mode, be surebutton.
to quit following this procedure)
2. Tape path check
2-2-2. HOW TO ENTER PLAYBACK MODE WITHOUT1) Clean the tape running side (tape guide, capstan shaft, pinch
CASSETTEroller).
1) Connect the adjustment remote commander to the LANC jack.2) Connect the adjustment remote commander to the LANC jack.
2) Turn the HOLD switch of the adjustment remote commander3) Turn the HOLD switch of the adjustment remote commander
to the ON position.to the ON position.
3) Close the cassette compartment without the cassette.4) Connect an oscilloscope to FU-141 board CN259 via the CPC-
4) Select page: 3, address: 01, and set data: 0B, and press the13 jig (J-6082-443-A).
PAUSE button of the adjustment remote commander.Channel 1: FU-141 board, CN259 Pin qh (Note)
(The mechanism enters the playback mode automatically)External trigger: FU-141 board, CN259 Pin qd
Note: The function buttons becomes inoperable.Note:Connect a 75 & resistor between Pins qh of CN259 and
5) To quit the playback mode, select page: 3, address: 01, set6 (GND).
data: 00, and press the PAUSE button of the adjustment re-5) Select page: 2, address: 2E, and set data: 01.
mote commander. (Whenever you want to quit the playback6) Playback the tape path check signal.
mode, be sure to quit following this procedure)7) Select page: 3, address: 33, and set data: 08.
8) Select page: 3, address: 26, and set data: 31.
9) Check that the oscilloscope RF waveform is flat at the en-
trance and exit.
If not flat, perform O2-1-2. TAPE PATH ADJUSTMENT O of
O2-1. Hi8/STANDARD 8 mm MODE�.
10) Select page: 3, address: 26, and set data: 00.
11) Select page: 3, address: 33, and set data: 00.
12) Select page: 2, address: 2E, and set data: 00.
Must be flat
Pin qh
Pin qd
Fig. 5-2-2
5-35 |
ACEC
