3-1. Setup Menu
3-1-4. Reference Menu
3-1-5. Triming Menu
3-1-4. Reference Menu
The Reference menu stores the reference values used for automatic setup adjustment and the standard settings of the
switches as the reference files. And the menu can clear the current reference files. The Reference menu is not normally
accessible. To display this menu, switch setting of the AT-95 board is required. For details, refer to Section 1-3.
OFunction of Internal SwitchesNAT-95 board�. To activate the Reference menu, first display the TOP menu.
m
1. Executing the FILE STORE on the REFERENCE FILE page registers settings of items, which have been set through
the Paint, Maintenance and System config menus just before the file store, as the reference values.
2. When changed numbers of items are returned to the reference values stored as the reference files, recall the standard
file using an MSU/RCP or the setup menu.
PageVer.ItemSettingsContents
REFERENCEFILE STOREPress MENU SELStores the adjustment value on each item as the reference value.
FILEswitch to execute.
CLEAR FILEPress MENU SELClears the adjustment values stored as the reference files.
p)
switch to execute.(Temporarily clears the current reference files .)
p) If the power is turned off without execution of the FILE STORE after clearing the file, the original setting is restored.
3-1-5. Triming Menu
The Triming menu stores the adjustment data in replacing parts as the triming files. And the menu can clear the current
adjustment values. The Triming menu is not normally accessible. To display this menu, switch setting of the AT-95 board
is required. For details, refer to Section 1-3. OFunction of Internal SwitchesNAT-95 board�. To activate the Triming
menu, first display the TOP menu.
n
Executing the FILE STORE on the TRIMING FILE page registers settings of items, which have been set through the
Maintenance and System config menus just before the file store, as the reference values.
PageVer.ItemSettingsContents
TRIMINGFILE STOREPress MENU SELStores the adjustment value on each item as the reference value.
FILEswitch to execute.
CLEAR FILEPress MENU SELClears the adjustment values stored as the triming files.
p)
switch to execute.(Temporarily clears the current triming files .)
OHB FILEFILE STOREPress MENU SELStores specific data for a CCD unit to be used as the OHB files.
switch to execute.The standard values are stored at the factory.
(Stores the offset value, OHB matrix data and so on.)
LENS FILE1.10LENS FILEPress MENU SELStores specific data for a lens to be used as the lens files.
STOREswitch to execute.The standard values are stored at the factory.
1.10SELECT[0] to 49Loads a lens data into the lens file selected at present by the LENS
CURRENTFILE page of the Operation menu.
LENS
1.10RESET ALLPress MENU SELResets all of 16 lens files.
LENSswitch to execute.(Example) No. : 1? Lens stored number (0 to 49)
Lens : 27 : A14x8BERM? Lens name
EX : 1.0? Lens extender value
p) If the power is turned off without execution of the FILE STORE after clearing the file, the original setting is restored.
3-12(E)BVP-550 |
ACEC
