SONY DMW-S01NL Repair Manual

6-1. Error Messages
6-1-4. Self Diagnostics Error Messages of Disk Utility
The following shows the error Messages of disk utility self diagnostics function and how to resolve them.
Error MessageMeaningCause/What to do
Please Log on as AdministratorsLog on user is not Administrators.Log on as Administrators groupOs user.
... Dmwdutil could not execute
Cannot get Driver HandleDevice driver is stopped.Run the device driver.
Device driver is not installed.Install the device driver.
FC board is incorrectly inserted to theInsert the FC board to the PCI slot correctly.
PCI slot.
Device did not respond ...Board is stopped.Reboot the system.
If not operation, replace the board.
FC Error Hdd-nodenameAny problems occur during HDD connections Check the HDD connection.
indicating at Nodename.
HDD has failed indicating at Nodename.Replace the HDD.
FC Controller number SRAM check NG SRAM on the FC controller has failed.Replace the FC board.
Cannot create file !Insufficiency capacity of the system HDD.Check possible capacity of the system HDD.
Diagnostic check was aborted.
Cannot create file !Insufficiency capacity of the system HDD.Check possible capacity of the system HDD.
Get Mode Parameter was aborted.
Diagnostic function error occurred.Self diagnostics cannot continue executing
Test was aborted.because error occurs during diagnostics
execution.
Get Data Failed.Communication failed to the firmware.
Defect Data-P Broken !!Communication failed to the firmware.This has failed in HDD.
Defect Data-G Broken !!
Format unit Error !HDD had been not in receipt of command.Replace the HDD.
Cannot get Formatting progress.Communication failed to the firmware.
But Format is running.
Cannot Get Progress.Communication failed to the firmware.
Cannot led Flash.LED flashing timer cannot be boot.It may consider that insufficiency of resources
(Timer could not start.)of the system.
SCSI Command Error !HDD had been not in receipt of SCSI
command as to HDD.
Get replace progress Timer could notReplace timer of HDD could not be boot.It may consider that insufficiency of resources
start.of the system.
Initialize failed (code).Problem occurs during data reception from
the firmware.
Install program process is incomplete !Failure of firmware down loadingDown load it again.
Wrong parameter.Data has wrong parameter.
Message ErrorFailure of message transmission to Servicing.
Cannot allocate memory !Failure of memory securingIt may possible consider that insufficiency of
resources of the system.
Dmwdalam service could not start.Failure of service starting
Dmwdalam service Stop Failed.Service could not be stopped.
Wrong node name (code)Nodename of selected HDD is unsuitable.Other initiator may possible to addition of the
Not Free Disk (code)Selected HDD was not Free status.system configuration change. Obtain the
latest information by FC Rescan execution.
Cannot Lock Disk (code)HDD could not be locked.Other system is used this HDD by locked.
6-8DMW-S01NL/S02NL/ST001