[TG-2 Guide]
No. 1 gear
1. Place the reference plate on the mechanical deck.
(Refer to Section 4-36. step 1.)TR arm hole
2. Rotate the No.1 gear so that the TR arm hole and
chassis hole shown in the figure are at the same
Chassis hole
position when seen from above.
3. Place the guide gauge on the reference plate,
push it to the guide lightly, and check that there
is no clearance between the guide gauge and the
lower flange.
If this is not satisfied, rotate the flange andTR arm hole
adjust.
Chassis hole
Guide gauge
TG-2 guide
Lower flange
Specification : No clearance
[TG-3 Guide]
Specification : No clearance
1. Place the reference plate on the mechanical deck.
Screw
(Refer to Section 4-36. step 1.)
Guide gauge
2. Place the guide gauge on the reference plate,
push it to the guide lightly, and check that there
is no clearance between the guide gauge and the
TG-3 Guide
upper flange.
If this is not satisfied, rotate the screw shown in
the figure and adjust.
[TG-7 Guide]
1. Place the reference plate on the mechanical deck.
Guide gauge
Specification : No clearance
(Refer to Section 4-36. step 1.)
TG-7 guide
2. Place the guide gauge on the reference plate,
push it to the guide lightly, and check that there
is no clearance between the guide gauge and the
upper flange.Lower flange
If this is not satisfied, rotate the flange and
adjust.
DSR-300/P(E)/V1
4-55 |
ACEC
