2-3. EXCHANGE METHOD OF BARRIER ASSY
Service parts
Part NumberPart NameQuantity1
13-091-427-01Ring (A), Ornamental1
2X-3954-476-1Barrier Assy1
33-086-156-31Tapping screw (P2)2
Tools used
Torque driver2
Soldering iron
Weight about 60g
Adhesive (Super X) (Note)
Note:Use adhesive (Super X) or an equivalent article.
DonOt use what becomes white after drying like a quick-drying glue.
3
2-3-1. PEEL OFF OLD ORNAMENTAL RING A
The Ornamental Ring A has adhered to the Barrier Assy strongly and accordingly, use a soldering iron to weaken the adhesive force.
Heat four circled portions with the soldering iron.
Heating temperature is about 3001C.
Beware of a burn since the entire Ornamental Ring becomes hot.
* As the adhesive force of Ornamental Ring A is considerably large, the forced peeling will damage the group-1 frame.
Insert the tip of tweezers, etc. into a notch of the group-1 frame and prize the ring.
* Take extreme care so as not to damage the coated surface of the group-1 frame.
In case of difficult peeling, heat the ring again with the soldering iron.
If this re-heating failed, it may be advisable that the ring be peeled while heating the portions 1 ? 2 ? 3 ? 4 in the under figure one
by one sequentially.
* Discard the removed Ornamental Ring A.
4
32
Tip1
DSC-P150
2-5 |
ACEC
