HCD-FC8/FC9
24. Auto track gain adjust2. DRIVE MANUAL OPERATION
Search CheckNote: This mode is used for design, and not used in service fundamen-
25. 32Tj forwardtally.
26. 32Tj reverse
27. 500Tj forwardOn the Test Mode Menu screen, press the [2] key on the remote
28. 500Tj reversecommander, and the Operation Menu will be displayed. For the
29. All servo stopmanual operation, each servo on/off control and adjustment can be
executed manually.
1-3. DVD-DL (dual layer)
Press the [3] key on the remote commander and insert a DVD dual## Drive Manual Operation ##
layer disc following the message. Then the adjustment will be madeOperation Menu
through the steps below, then adjusted values will be written to the 1. Disc Type
EEPROM. 2. Servo Control
3. Track/Layer Jump
DVD Dual Layer Disc Adjustment Steps: 4. Non EEPROM Write Adjust
1. Sled tilt reset 5. EEPROM Write Adjust
2. Disc check memory DL 6. Memory Check
3. Wait 500 msec 7. Disc Check Memory
4. Set disc type DL 8. Error Rate Display
5. LD on 9. SACD Water Mark
6. Spindle start
7. Wait 1 secExit: RETURN
Layer 1 Adjust
8. Focus servo on 0
9. Auto track offset adjustIn using the manual operation menu, take care of the following
10. CLVA onpoints. These commands do not provide protection, thus requiring
11. Wait 500 mseccorrect operation. The sector address or time code field is displayed
12. Tracking onwhen a disc is loaded.
13. Wait 500 msec
14. Sled onNote:
15. Check CLV lock1. Set correctly the disc type to be used on the Disc Type screen.
2. In case of an alarm, immediately press the x button to stop the
16. Auto loop filter offset adjust, Auto focus adjust
17. Auto focus gain adjustservo operation, and press the @/1 button to turn the power off.
18. Auto focus offset adjust
19. EQ boost adjust
20. Auto loop filter offset adjust
21. Auto Track Gain AdjustBasic operation:
(controllable from front panel or remote commander)
Search Check
22. 32 track jump forward @/1:Power OFF (release the Test Mode)
x: Servo stop
23. 32 track jump reverse
24. 500 track jump forward A (DISC1 to 5): Stop and eject/Loading
[RETURN]: Return to Operation Menu or Test
25. 500 track jump reverse
Layer 0 AdjustMode Menu
[ PREV]., [NEXT ]> :Transition between sub modes of menu
26. Focus jump (L1 t L0)
27. Auto track offset adjust L0[1] to [9], [10/0]: Selection of menu items
Cursor o / O: Increase/Decrease in manually
28. CLVA on
29. Wait 500 msecadjusted value
30. Tracking on
31. Wait 500 msec
32. Sled on
33. Check CLV lock
34. Auto focus filter offset adjust
35. Auto Focus Adjust
36. Auto focus gain adjust
37. Auto focus offset adjust
38. EQ boost adjust
39. Auto Loop Filter Offset
40. Auto track gain adjust
Search Check
41. 32 track jump forward
42. 32 track jump reverse
43. 500 track jump forward
44. 500 track jump reverse
Layer Jump Check
45. Layer jump (L0 ? L1)
46. Layer jump (L1 ? L0)
47. All servo stop
29 |
ACEC
