SECTION 4
TEST MODE
Note 1: About OR�
As this unit has only a few buttons, some operations require the use of remote commander (RM-SJ373/pro4-11)vided with unit: 1-418-55
buttons. These operations are indicated as OR� in this manual.
Example: MENU/NO OR� ...Press the MENU/NO button of the remote commander.
4-1. PRECAUTIONS FOR USE OF TEST MODE
Y As loading related operations will be performed regardless of the test mode operations being perfhe disc isormed, be sure to check that t
stopped before setting and removing it.
Even if the A (MD) button is pressed while the disc is rotating during continuous playback, continuous recording, etc., the disc will not
stop rotating.
Therefore, it will be ejected while rotating.
Be sure to press the A (MD) button after pressing the MENU/NO OR� button and the rotation of disc is stopped.
4-1-1. Recording laser emission mode and operating buttons
Y Continuous recording mode (CREC MODE)
Y Laser power check mode (LDPWR CHECK)
Y Laser power adjustment mode (LDPWR ADJUST)
Y Traverse (MO) check (EF MO CHECK)
Y Traverse (MO) adjustment (EF MO ADJUST)
Y When pressing the zMD button.
4-2. SETTING THE TEST MODE
The following are two methods of entering the test mode.
Procedure 1:Press the FUNCTION button, and set the function to OMD � before hand. When the power ON?/1, press the button while
pressing the s button and z TAPE button together.
When the test mode is set, O[Check]� will be displayed. Pressing the lm/TUNING � button or ML/TUNING +
button switches between the following four groups; áááNn Check Nn Adjust Nn Service Nn Develop Nn ááá.
Procedure 2:Press the FUNCTION button, and set the function to OMD � before hand. When the power ON, press the ?/1 button while
pressing the s button and STAPE button together.
When the test mode is set, OTEMP CHECK � will be displayed. By setting the test mode using this procedure, only the OCheck�
group of procedure 1 can be executed.
4-3. EXITING THE TEST MODE
Press the REPEAT/DOLBY NR/STEREO/MONO button.
4-4. BASIC OPERATIONS OF THE TEST MODE
All operations are performed using the lm/TUNING � button or ML/TUNING + button, ENTER/YES OR� button, and
MENU/NO OR� button.
The functions of these buttons are as follows.
Function nameFunction
lm/TUNING � button or ML/TUNING + buttonChanges parameters and modes
ENTER/YES OR� buttonProceeds onto the next step. Finalizes input.
MENU/NO OR� buttonReturns to previous step. Stops operations.
29 |
ACEC
