TOP COVER HS ASSOY, BOTTOM COVER MF ASSOY, F PANEL ASSOY R237
1 two screws2 Remove top cover HS assOy
(P2.6 � 3)in the direction of arroA.w
A
5 F panel assOy R237
B
4 Remove bottom cover
MF assOy in the direction
of arroBw .
3 four screws
(P2.6 � 5)
3 two screws
(P2.6 � 5)
Note: 1.Before reassembling F Panel AssOy R237Mecha UD Sub SL
be sure that the end of the Mecha UD Sub
Cam SL on the right front does not protrude
as shown in (Fig. B.1). If it protrudes, move
it backward as follows:
1) Carefully remove the left side adhesive
label (Dust Seal EMA SL) on the left side
of the unit. refer to (Fig. B.2)
2) Turn the Emergency Gear SL with your
finger tip in the direction of the arrow
until the end of the Mecha UD Sub Cam
SL is drawn inside the unit. (See Fig. B.2).
When turning the GearDO NO, T use nail
as the gear tooth can be broken.
(Fig. B.1)3) Reattach the adhesive label (Dust Seal EMA
SL).
Note: 2.Be sure that the claws of F POy R237 areanel Ass
securely inserted into each holes in Top Cover HS
AssOy and Bottom Cover MF assOy.
Emergency Gear SL
(Fig. B.2)
10 |
ACEC
