SECTION 2
GENERAL
This appliance is classified as a CLASS 1 LASER product.LOCATION OF CONTROLS
The CLASS 1 LASER PRODUCT MARKING is located on� Front Panel �
the rear exterior.
234
1
wf
wd5
Laser component in this product is capable of emitting radiation6
exceeding the limit for Class 1.ws7
wa
The following caution label is located inside the unit.w;8
ql9
qk0
qa
qj
qs
qd
qhqgqf
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
The laser diode in the optical pick-up block may suffer electro-
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused
on the disc reflective surface by the objective lens in the optical� Rear Panel �
pick-up block. Therefore, when checking the laser diode emis-2
sion, observe from more than 30 cm away from the objective lens.
Notes on chip component replacement
Y Never reuse a disconnected chip component.
Y Notice that the minus side of a tantalum capacitor may be dam-1
aged by heat.9
8
Flexible Circuit Board Repairing7
Y Keep the temperature of the soldering iron around 270 uC dur-6
ing repairing.
Y Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
Y Be careful not to apply force on the conductor when soldering
or unsoldering.
5
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous ra-
diation exposure.
43
4 |
ACEC
