HCD-DX20/RG30
[Aging Mode]
This mode can be used for operation check of CD section and tape deck section.
Y If an error occurred:
The aging operation stops and display status.
Y If no error occurs:
The aging operation continues repeatedly.
1. Operating method of Aging Mode
Turn on the main power and select CD of the function.
1) Set a disc in DISC1 tray. Select ALL DISC CONTINUE, and REPEAT OFF.
2) Load the tapes recording use into the decks A and B respectively.
3) Press three buttons x , ENTER , and
DISC SKIP EX-CHANGE simultaneously.
4) Aging operations of CD and tape are started at the same time.
5) To exit the aging mode, perform [MC Cold Reset].
3. Aging Mode in CD section
1) Display state
Y No error occursDisplay
AGING[*][*][*][*]
Note:
[*][*][*][*] : Number of aging operations
Error display
E ** s ## $$ %%
1 234 5
1 **The error No. 00 indicates the newest error. As the error No. increases, it means the older error.
When you want to retrieve the error history, press the PLAY MODE button in the case of mechanism error.
Or press the REPEAT button in the case of NO DISC error.
2 s M: Mechanism errorD: No disc error
3 ## Dont care01: FOCUS ERROR
02: GFS ERROR
03: SETUP ERROR
4 $$ High order digits only01: NO DISC judgment without chucking retry
D: Stopped during closing due to problems other than mechanism.02: NO DISC judgment after chucking retry
E: Stopped during opening due to problems other than mechanism.
C: Stopped during chucking due to problems other than mechanism.
F: Stopped during EX-opening due to problems other than mechanism.
5 %% Emergency related errors (High order digits only)Status at the time of NO DISC judgment
1: Stopped during chuck-up(High order digits only)
2: Stopped during chuck-down1: STOP
3: Time out by EX-OPEN2: SETUP
5: Time out by EX-CLOSE3: TOC READ
4: ACCESS
5: PLAY BACK
6: PAUSE
7: MANUAL SEARCH (PLAY)
8: MANUAL SEARCH (PAUSE)
Y When the buttons x , ENTER and DISC 1 are pressed simultaneously, number of time of the mechanism error and the NO DISC error
can be checked.
Display: EMC**EDC****:Number of times of error (Maximum three times)
EMC: Mechanism error
EDC: NO DISC error
Y When aging operation is complete, be sure to perform the MC Cold Reset to reset the error history.
15 |
ACEC
