[Aging Mode]4. Aging mode in Tape Deck section
This mode can be used for operation check of CD section and tape1) Display state
deck section.Y No error occurs
Y If an error occurred:Display action now
The aging operation stops and display status.Y Error occurred
Y If no error occurs:Display action last time
The aging operation continues repeatedly.
NO. Display actionAction contentsFinal timing
1 TAPE A AG-1 Rewind the TAPE AThe top of tape
1. Operating Method of Aging Mode
1) Set disc in DISC1 tray.2 TAPE A AG-2 FWD play the TAPE A 3 minutes playing
2) Load the tapes recording use into the decks A and B r3TAPE A espec-AG-3 F.F. the TAPE AFirst either 20 minutes
tively.or the end of tape
3) Press three buttonsp , [ENTER/NEXT],4 TAPE A AG-4 REV play the TAPE A 3 minutes playing
and [DISCESKIP/EX-CHANGE] simultaneously.5 TAPE A AG-5 Rewind the TAPE AThe top of tape
4) The aging mode is activated, if a CD roulette mark on the fluo-6 TAPE B AG-1 Rewind the TAPE BThe top of tape
rescent indicator tube is blinking.
7 TAPE B AG-2 FWD play the TAPE B 3 minutes playing
5) To exit from the aging mode, prI/u button to turn the setess8 TAPE B AG-3 F.F. the TAPE BFirst either 20 minutes
OFF.or the end of tape
2. Operation Sequence9 TAPE B AG-4 REV play the TAPE B 3 minutes playing
Y During the aging mode in the following sequence to belo10TAPE B wA.G-5 Rewind the TAPE BThe top of tape
Y Starting the CD section aging for function set OCD�, starting
the TAPE section (deck A) aging for function set OT2) OperAPE aA� ortion during Aging Mode
OTAPE B�. (Set another function is no work.)In the aging mode, the program is executed in the following se-
CD (disc1) (12 minutes) ? Deck Aüquence.
�ý(About 13 minutes(1) Rewind is executed up to the top of tape.
Deck BÅ£ 20 seconds(2) A tape on FWD side is played for 3 minutes.
maximum)(3) FF is executed up to either made for 20 minutes or the end of
tape.
3. Aging mode in CD section(4) A tape is reversed, and the tape on REV side is played for 3
1) Display stateminutes.
Y No error occurs(5) Rewind is executed up to the top of tape.
display(6) Steps 1 through 5 are executed for the other deck.
(7) Change to CD section aging.
[*][*] 1 �@ @
Note:
[*][*] : a letter OCD� and the remainder time (minute) alternately. (re-
mainder time start from 12 minute)
@@:track number in access.
Y Error occurred
NO.DisplayMain factor
1 NO DISC ERR Not set disc in DISC1
2 FOCUS1 ERR Focus does not work
3 FOCUS2 ERR Focus does not work after the disc rotate as usual
4 GFS ERRGFS error
5 FBIAS ERRError in to the focus bias adjustment
6 SENSOR ERR Disc sensor sens DISC1 is no disc
7 TABLE ERRCD tray lotate does not work
8 TRAY ERRTray (include BD) move does not work
2) Operation during aging Mode
In the aging mode, the program is executed in the following se-
quence.
(1) The disc tray turns to select a disc1.
(2) A disc is chucked.
(3) TOC of disc is read.
(4) The pickup accesses to the track 1, and playing 2 seconds.
(5) The pickup accesses to the last track, and playing 2 seconds.
(6) Steps 1 through 5 are repeated about 12 minutes.
(7) Change to deck section aging.
� 12 � |
ACEC
