3-9. FITTING BASE (GUIDE) ASSY, BRACKET (CHASSIS) AND
FITTING BASE (MAGNET) ASSY
7 four screws
(BVTP M2.6)
2 four screws
(BVTP M2.6)8 base (magnet) assy, fitting
4 five screws
(BVTP M2.6)
6 connector
(CN710)
5 bracket
(chassis)
3 base
(guide) assy, fitting
1 two connectors
(CN709, 715)
3-10. TRAY (SUB)
1 Rotating the pulley (LD), shift the slider (selection) in the arrow A direction.
2 Rotating the pulley (mode) in the arrow direction, adjust the tray (sub) to be removed.
3 Rotating the pulley (LD), shift the slider (selection) in the arrow B direction.
4 Rotating the pulley (mode) in the arrow direction, remove the tray (sub) to be removed.
slider (selection)
pulley (LD)
stocker
section
A
B
pulley (mode)
tray (sub)
21 |
ACEC
