Section 2
Replacement of Main Parts (HDC-900)
2-1. Replacing the CCD Unit4. Remove the four hexagon-socket bolts, remove the
four spring washers, and remove the front panel
nassembly.
Never remove or install the CCD unit with the power
turned on. Because touching internal harness to the cabinet
or other printed circuit boards during replacement causes
shorts or electric hazards.
Prior to replacement, be sure to disconnect the optical
cable or the cable connected at the DC IN connector in
addition to turning off power switch.
Spring
1. Open the right side panel. (Refer to Section 1-4 of thewasher
Installation and Maintenance Manual.)
2. Loosen the screw of mount lever fixing lid, and open
the mount lever fixing lid in the arrow direction.
3. Loosen the four screws of front assembly, and remove
Front panel assembly
the front assembly.Hexagon-socket bolts
(3 x 8)
5. Disconnect the harness connector from the connector
of CCD unit, loosen the two fixing screws of the filter
disk unit, and remove the filter disk unit.
CCD unit
Front assembly
Filter disk unit fixing screw
PWH4 x 12(with stopper)
(With stopper)
Filter disk unit
Connector
PWH4 x 12
(With stopper)
Filter disk unit fixing screw
Mount lever fixing lid
(with stopper)Harness connector
Screw
HDC-900/950 MM2-1 (E) |
ACEC
