1-5. Replacement of Main Parts
(9) Install a new fan in the reverse order of the steps (1) through (8).
m
. When installing the fan, take care the direction of the airflow.
. When installing the fan, put the harness in the notch of the fan shown in the figure. After installing the
fan, pulll out the harness in the direction of the arrow and secure the harness to the harness holder.
If loosening the harness, the harness causes that be caught in the fan when turning the fan.
. Install the fan tray to the unit with caring the following comments shown below.
When the fan tray is difficult to install,
remove the plug-in board in the top of the
fan tray to be installed, installed, once
and confirm that the screws are visible.
Fan fixing screw
Engage here.Guide rail mounting
plate (unit)
Fan tray
1-5-2. Capacitor for Data Backup
To store a setup data and a real-time clock, the large storage capacitor (3 Farad) is mounted on the CPU-
183 and CKG-10 boards.
To charge the large storage capacitor sufficiently, turn on the power of HDME-7000 for more than about
thirty minutes. The sufficiently charged large storage capacitor enables data to be stored for about one
week in the normal temperature.
1-12 (E)HDME-7000 MMP1 |
ACEC
