kwise position
le to do so, offset the
ed.
ed.
GENERAL ADJUSTMENTSth. If it is impossib
e the entire screen.
T-drive printed circuit board, and set it to the positionner area become minimiz
acing south or nor
k lines of the cor
ve for adjustment to optimiz
SPECIFIC INFORMATIONS
Conditions: PAL Retoma signal, User Adjustment Standard Adjustment: Use the focus volume of the focus block (T461), and set it to the most counterclocwhere the lateral fly-back lines of the screen center become minimizConditions: PAL Retoma signal WIDE mode, User adjustment standard Adjustment: Use the sub-focus volume (R950) on the CRwhere the longitudinal fly-bacRepeat Items 1 and 2 aboConditions: PAL WG Philips Pattern WIDE mode, User Adjustment Standard Adjustment: Use [VPS1] and adjust so that the top and bottom positions will contact the mask. (Adjust with the direction of CPT either fdifference.)
Adjusting itemsAdjusting methods
Focus adjustment (1) FOCUS VRFocus adjustment (2) R950Adjustment of vertical position
olume/data adjustment)
36ZP18P 32ZP18P36ZP18P 32ZP18P
12
No.Target model names
2. Circuit adjustment (V
� 15 � |
ACEC
