ITEMADJUSTMENT PROCEDURE
WHITE BALANCE1. Set Contrast to 40, and brightness to +20 by picture control.
ADJUSTMENT2. Set the TV in service mode, and get the inside W/B adjusting signal with VIDEO
button.
YCUTOFF ADJUSTMENT3. Select RCUT, GCUT and BCUT with CHANNEL s, t buttons, to set individual
(RCUT)values to Initial reference data, and to set GDRV and BDRV to Initial reference
(GCUT)data with VOLUME ; � /+ buttons.
(BCUT)4. Press -/- - button on the remote control and rotate Screen VR to get one slight
horizontal line on screen.
YDRIVE ADJUSTMENTNote: Every pressing of -/- - button provides Horizontal line picture and Normal
(GDRV)picture alternately.
(BDRV)5. Press -/- - button to release horizontal line picture, and select the two other colors
which did not light in the above step with CHANNEL s, t buttons. Then tap VOL-
UME ; � /+ buttons so that three colors slightly light in the same level.GENERAL ADJUSTMENTS
X To correct white balance in light area,Light area check
select GDRV and BDRV with CHANNEL(to show white)
s, t buttons to adjust.
X To correct white balance in dark area,
perform fine adjustment of RCUT, GCUT
and BCUT.
Dark area check
(to show black)
SPECIFIC INFORMATIONS
� 11 � |