REPLACEMENT OF THE CRT
Service parts are provided for each R, G and B.
The contents of the parts are as follows.
RGB
HITACHI
CRT230081742300817523008176
GENERAL ADJUSTMENTSREPLACEMENT OF HIGH VOLTAGE CABLE
1. When replacing Anode Lead or Anode Cap with new one,
remove Lead Holder from old lead as shown in figure
ANODE LEADbelow, and put it on new lead. Do not throw away Lead
Holder.
NOTE : THE LEAD HOLDER IS ATTACHED TO TPA5007
RUBBER BOOT(Z450), BUT IS NOT ATTACHED TO ANODE
LEAD AND ANODE CAP. RUBBER BOOT IS AT-
TACHED TO ANODE LEAD AND ANODE CAP.
LEAD HOLDER
2. Detaching Lead Holder
OLD
RUBBER BOOT ANODE LEADSPECIFIC INFORMATIONS
or
ANODE CAP
LOCKLEAD HOLDERCut here rubber boot
and lead together to
Z450 TPA5007detach Lead Holder.
Fig. aFig. b
� 9 � |