CONVERGENCE ADJUSTMENT
Adjust convergence from center to circumference in order1. Select the adjustment mode f.ollowing the steps on page 9
of original servicemanual.
KEY FUNCTION IN THE CONVERGENCE ADJUSTMENT:
Up :2 buttonRCUT
Selet Green color:3 button40H
Left :4 button
Blinking of cursor ON/OFF:5 button
Right:6 button
Adjust mode ON/OFF:7 button
Down:8 button
Erase Green line:0 button
Erase Red line:100 button
2. Press O7� button to display the built-in cross-hatch pattern.
Erase Blue line:CHRTN (ENT) button
Cursor
21.5 (43")
26.5 (50")
28.5 (55")
31.0 (61")
P= 43.7�14 (43")
50.5�14 (50")
55.8�14 (55")
62�14 (61")
21.5 (43")
26.5 (50")
3.5 (43", 50")P=72.2�12 (43") 3.5 (43", 50")28.5 (55")
4.0 (55")84.0�12 (50") 4.0 (55") 31.0 (61")
5.0 (61")92.5�12 (55")5.0 (61")
102.5�12 (61")
Note:The pattern includes three colors (R, G, B).
Adjusting procedure in replacing convergence board.The cursor should be blinking in Red.
1. User convergence center check. Make sure the best con-This means that the Red color is adjustable.
vergence setting is about the center of adjustabAdjustment around cursor can be donele range..
2. CENTERING ADJUSTMENT3. Press O3� button to select Green color to be adjusted.
3. PICTURE POSITION ADJUSTMENT4. Press O5� button to stop the blinking of cursor.
4. HIT, WID ADJUSTMENT5. Press O2 (up)�, O8 (down)�, O4 (left)� or O6 (right)� to obtain
5. CONVERGENCE ADJUSTMENTthe correct cross-hatch pattern as above.
If necessary, the specified color line can be erased from
the screen.
100 button ...................... to erase Red line
0 button ...................... to erase Green line
RTN (ENT) button ...................... to erase Blue line
6. Press O5� button to make the cursor blinking.
7. Press O2�, O8�, O4�, O6� buttons to move the cursor to other
point to be adjusted.
8. Repeat steps 4 to 7.
9. Repeat steps 3 to 8 to adjust Red and Blue colors.
Converge the selected color line into the Green line.
10. Press O7� button to memorize the adjusted states.
At this time, picture changes for about 1 second.
11. Press O7� button again to return to the normal picture.
� 2 � |
ACEC
