Less than ż7mmUpper and lower flags are to be in contactThe inner circle is to contact the screen edge
Adjustment standard
GENERAL ADJUSTMENTS
screen positions and centering magnet so that the central + mark of the dummy screen and the + mark of the Phillips pattern can overlap in conformity. Carry this out individually on 3 tubes of R, G, and Bamplitude using HIT data until the upper and low flags emerge on the screen.the HIT data until either upper or lower flag end conforms to the screen end (Adjust the vertical center of the pattern to the central mark of the screen.)bottom of the inner circle of Phillips pattern will contact the screen edge. (Note) VLIN adjustment is not performed.bottom of the Phillips pattern
(1)Adjust the vertical and horizontal(Note) Do not move HPOS, VPOS data(1)Turn the screen size to WIDE. (2)In the first place, shorten the vertical(3)Then, extend the vertical amplitude with(1)Turn the screen size to Super-live. (2)Adjust with the HIT so that the top and(1)Turn the screen size to CINEMA. (2)Adjust the registers on the top and(Note) Do not touch the centering magnet
Screen adjustmentScreen adjustmentScreen adjustmentScreen adjustment
Completion of adjustment
Phillips pattern (PAL-I)Phillips pattern (PAL-I)Phillips pattern (PAL-I)Phillips pattern (PAL-I)
Picture mode 1Picture mode 1 WIDE modePicture mode 1 Super-live modePicture mode 1 CINEMA mode
Vertical ampli- tude adjustment (PAL WIDE)Vertical ampli- tude adjustment (PAL Super-live)Vertical ampli- tude adjustment (PAL cinema)
ItemNameSettingInput signalMeasuring pointAdjusting method
Screen position adjustmentHIT VLINHITHIT
� 19 � |
ACEC
