Adjusting standards 1.5 bars
?
starts lighting11500k +0.0075duV10500k +0.0105duV
).
2
).
2
ight4
k).
ical focus and
y Tube and
..ts lighting.
GENERAL ADJUSTMENTS
vel up to the1.80Vop.or each tube of G, R,or each tube of G, R,
.2.0Vop
T except the axes under 10mV by VPOS data.
ainbow color bar .1.50Vopy repeating electr?y screen (cross mar
.
ature of the bright part (103cd/mature of the dark part (17cd/m
W/B, SCNT.
VR to the point that staroltmeter between TP-V
alue of the upper half)ing magnet so that the posotion of screen
(Y mute, DRV.CUT=40H)adjust the screen and B.adjustment.and B..
3)Adjust the COLC after adjusting the SCNT3)Adjust the COLS after adjusting the COLC3)Directly observe the surface of Cathode Ra4)Make above-mentioned adjustments f2)Use the jig and shade the CR3)Make above-mentioned adjustments f
adjustmentoptical focus adjustments
(J2ch)white peak.signaladjustmentsignals. (J2ch)2)Adjust after adjusting (J2ch)2)Confirm that video muting is made.(E2ch)2)Adjust the P-P value of the upper half(PAL)and TP-Gand TP-G, and adjust it to 0
Dynamic modePhilips PatternBetween TP-V1)Connect a digital v
NTSCsignal(Adjust the P-P vSECAMcolor bar(Apply video muting at the time of adjustment)
ItemsNamesSettingsInput signalsMeasuring pointsAdjusting methods
SCNTSub-contrastDynamic modeSub-bright signalTP46R1)Adjust amplitude from the pedestal leBRTCSub-brightnessDynamic modeSub-brightScreen1)Adjust the number of black collapsed lines of sub-brCOLCSub-colorDynamic modeSub-brightTP46B1)Adjust the amplitude of the rCOLSSub-colorDynamic modeSECAMTP46B1)Adjust the amplitude of the color barScreenScreenFactory screenCRT tubular1)Darken the environment as much as possible.Point that adjustmentadjusting modescreen2)Set to factory-set screen adjusting MODE.FocusFocusDynamic modeRetma signalScreen1)Adjust to the best position badjustmentDot-cross signalRDRVBright partScreen1)Adjust the color temperBDRVW/BadjustmentRCUTDark part W/BScreen1) Adjust the color temperBCUTadjustmentVoltage measure- ment at vertical midpointScreenDynamic modePhilips PatternScreen1)Adjust the centerpositioning(PAL)Set: Face to eastis in the center of the dummadjustment
� 15 � |
ACEC
