PROGRAMMING CHANNEL MEMORY
The channel memory is the list of TV channel numbers the TV tunes in when you press the CHANNEL s or t button.
First, use the TV/CABLE and CH PROGRAM functions to preset all active channels in your area automatically.
If necessary, arrange the preset channels with the ADD/ERASE functions so that you can tune into only desired channels.
Note: If you utilize both ANT-1 and ANT-2 terminals for some model, perform programming channels for each input source.
TV/CABLE functionADD/ERASE function
1Press MENU, then press S or T until the SET UP menuAfter performing the CH PROGRAM function, you can add or
GENERAL ADJUSTMENTSappears.erase specific channels.
2Press t (or s) until OTV/CABLE� is highlighted.1Select the channel you want to erase using the CHANNEL
s or t button, or select the channel you want to add using
3Press : or ; to highlight either OTV� or OCABLE�, whicheverthe Channel Number buttons.
you use.
2Press MENU, then press S or T until the SET UP menu
appears.
3Press t (or s) until OADD/ERASE� is highlighted.
CH PROGRAM function
1Select OCH PROGRAM� following steps 1 and 2 above.4Press S or T :
To erase the channel press the button until OERASE� is
2Press : or ; to start channel programming.highlighted.
The TV will automatically cycle through all the TV or
SPECIFIC INFORMATIONSCABLE channels selected by the TV/CABLE function, andTo add the channel press the button until OADD� is
store active channels in the channel memory.highlighted.
3When channel programming is complete, you will see the5Repeat steps 1 to 4 for other channels.
message to the right appears.
You have now completed the channel programming.
4Press CHANNEL s or t to make sure the channel
programming has been done properly.Note: The CHANNEL t/s buttons on the TV function as the
t/s buttons while a menu is on the screen.
* Please refer to owner's manual in detail.
� 21 � |
ACEC
