CONVERGENCE ADJUSTMENT
Adjust convergence from center to circumference in order1. Select the adjustment mode f.ollowing the steps on page
9.
KEY FUNCTION IN THE CONVERGENCE ADJUSTMENT:
RCUT
Up :2 button40H
Selet Green color:3 button
Left :4 button
Blinking of cursor ON/OFF:5 button
Right:6 button
Adjust mode ON/OFF:7 button
Down:8 buttonGENERAL ADJUSTMENTS
Vertical stripe ON/OFF9 button
Erase Green line:0 button
2. Press O7� button to display the built-in cross-hatch pattern
Erase Red line:100 buttonand press "9" button to display the vertical stripes.
Erase Blue line:ENT button
Note:
Adjusting procedure in replacing convergence board.Cursor
1. User convergence center check. Make sure the best con-
vergence setting is about the center of adjustable range.X: I
2. CENTERING ADJUSTMENTY: I
3. PICTURE POSITION ADJUSTMENTC: R
FULL
4. HIT, WID ADJUSTMENTFULL
5. CONVERGENCE ADJUSTMENT
6. Execute TOUCH FOCUS following instructions displa3. Adjustment around cursor can be doneyed.
on the screen after finishing CONVERGENCE ADJUSTThe patter-n includes three colors (R, G, B).
MENT.The cursor should be blinking in Red.
7. If TOUCH FOCUS ERROR is displayed after finishingThis means that the Red color is adjustable.
TOUCH FOCUS, the method of CROSS-HATCH PAT-4. Press O3� button to select Green color to be adjusted.
TERN after CONVERGENCE adjustment is different from5. Press O5� button to stop the blinking of cursor.
what is exhibited on the right figure, or HARD6.WARE is outPress O2 (up)�, O8 (down)�, O4 (left)� or O6 (right)� to obtain
of order.the correct cross-hatch pattern as above.
If necessary, the specified color line can be erased from
the screen.
100 button ...................... to erase Red line
0 button ...................... to erase Green line
CH RTN button ...................... to erase Blue line
7. Press O5� button to make the cursor blinking.
8. Press O2�, O8�, O4�, O6� buttons to move the cursor to other
point to be adjusted.
9. Repeat steps 5 to 8.
10. Repeat steps 4 to 9 to adjust Red and Blue colors.
Converge the selected color line into the Green line.
11. Press O7� button to memorize the adjusted states.
At this time, picture changes for about 1 second.
12. Press the TOUCH FOCUS button when "PLEASE PUSH
TOUCH FOCUS" is displayed on the screen.
13. TOUCH FOCUS is executed.
14. It returns to the normal screen after displaying "TOUCH
FOCUS FINISHED".
� 13 � |
ACEC
