WHIRLPOOL CONSUMER SERVICES Model AWM5080
Page 19 of 21
TEST SEQUENCE
Step Advance to stepPump OutTemper-TimeDrumComponent(s)Comments
by pressing :or Fill Via :atureRhythmChecked
(See Note 1)
1Begin test byPrewash Cold fill 60 s (fill) Stationary Eco button andIf test fails to start, check
pressing Eco threeNTCNTC or Eco button.
times. TimerIf Rapid button is not
advances past 2pressed, the machine will
pump out and stop
2Rapid button oncePrewash Cold fill 60 s (fill) Stationary Rapid button andIf Rapid button is not
Timer advancesprewash fillpressed, the machine will
past 3pump out and stop
3Intensive rinsePrewash Cold fill,60 s (fill) Stationary Intensive rinseIf Intensive rinse button is
button onceheater onbutton, heatingnot pressed, the machine
Timer advances 1element, NTCwill pump out and stop
step
4Easy ironing buttonPrewash Cold fill,60 s (fill) Stationary Easy ironing button If Easy ironing button is
once. Timerheater offnot pressed, the machine
advances 1 stepwill pump out and stop
5800/500 buttonMainCold fill,60 s (fill) 10 s on,800/500 button,IF the 800/500 button is
once. Timerwashheats to6 s offheater, doornot pressed, the machine
advances to 9 andset temp-switch, NTCwill pump out and stop.
then past 10 after filleratureSee Note 3, Page 18
6Timer advancesMainCold fill,60 s (fill) 10s on,Heater termination If the test is advanced
automatically 3washheater off6s offbefore the completion of
stepseach step the drum
rhythm will change
7Timer advancesFabricCold fill 60 s fill,10s on,Drain pump-
automatically past AsoftenerPump out6s off
8Timer advancesPump out -Pump out Spin maxMain motorSpins for 300 s, then
automatically past Bspeedadvances past C and
stops
The test sequence can be terminated at any time by pressing the On/Off switch to Off, setting
the timer on "D" and pressing the On/Off switch to on. The pump will run and then the timer will
rotate to the Stop position.
If a failure is detected during the test sequence the timer will :
1.Initiate the safety step routine :
A. Drain pump runs until pressure switch resets plus 30 seconds.
I. Main motor is turned off.
II. Water inlet valves are turned off.
III. Element is turned off
2.Stop the machine but does not give a visual signal to indicate a fault. |
ACEC
