Troubleshooting
English
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
SymptomCauseAction
Unable to cancel the display demonstration.Other buttons are pressed to cancel thePress CANCEL/DEMO on the unit. (See
display demonstration.page 8.)
No sound is heard.Connections are incorrect or loose.Check all connections and make
corrections. (See pages 6 to 8.)
Hard to listen to broadcasts because ofY Antennas are disconnected.Y Reconnect the antennas correctly and
noise.securely.
Y The AM loop antenna is too close to theY Change the position and direction of the
unit.AM loop antenna.
Y The FM antenna is not properly extendedY Extend the FM antenna at the best
and positioned.position.
The disc sound is discontinuous.The disc is scratched or dirty.Clean or replace the disc. (See page 26.)
The carrousel does not open or close.Y The AC power cord is not plugged in.Y Plug the AC power cord.
Y The carrousel is locked.Y Unlock the carrousel. (See page 19.)
The disc does not play.The disc is placed upside down.Place the disc with the label side up.
The MP3 disc does not play.Y No MP3 files are recorded on the disc.Replace the disc.
Y MP3 files do not have the file
extensionN.MP3, .Mp3, .mP3, or .mp3 in
their file names.
Y MP3 files are not recorded in the format
compliant with ISO 9660 Level 1 or
Level 2.
The readout time of the MP3 disc is tooThe readout time varies with the complexityDo not use too many hierarchies and folders
long.of the recording configuration.when recording. Also, do not record any
other types of audio tracks together with
MP3 files. (See page 13.)
The cassette holders cannot be opened.Power supply from the AC power cord hasTurn on the unit.
been cut off while the tape was running.
Impossible to record.Small tabs on the back of the cassette areCover the holes with adhesive tape.
removed.
Operations are disabled.The built-in microprocessor mayUnplug the AC power cord and then plug it
malfunction due to external electricalback in.
interference.
Unable to operate the unit from the remoteY The path between the remote control andY Remove the obstruction.
control.the remote sensor on the unit is blocked.
Y The batteries are exhausted.Y Replace the batteries.
27
EN21_28MXGT88&GA77[C].pm62703.1.14, 3:59 PM |
ACEC
JVC
