Auto Setup for DOS
If the monitor is in st1.andby Turn on the monitor first; then the PC.
mode (STANDBY ON), it
may automatically turn off while If the message CHECK SIGNAL CABLE is displayed, or if nothing is
you are waiting for it to warm up.di splayed check:
If this happens, switch off the that the video interface cable is connected properly
monitor and switch it on again
after a few seconds. the correct video adapter card is installed
the correct supported display mode is selected for your PC.
If your system goes into standby
mode again, reboot your system 2.Wait approximately 15 minutes, until the monitor warms up.
and change the system Bios 3.Insert the diskette labelled ?IBM Monitor Installation Disk? into the
Setup Utility to DISABLE Power
Saving. Refer to your system diskette drive.
manual.
4.Display the command prompt screen of the DOS full-screen display.
If you are using PC-DOS5./At the command prompt, ty?A: an?pe d press ENTER.
V, change to U.S. mode by
typing ?CHEV US? and pressing 6.Type?TES TPATD? and press ENTER.
ENTER at the command 7.Select from the screen the number for the color or text mode you want to
prompt.
setup.
You must use DOS or 8.Select from the screen the number for the video mode you want to
OS.2 DOS Full Screen setup.
(not under Windows or
OS/2 DOS window, OS/2 You may repeat this process for as many of the color and video modes
window, or OS/2 full screen)
when you run DOS Auto as you need.
Setup.9.When the dot pattern appears, press the OSD Enter button at the
bottom of the monitor to display the initial OSD menu.
The size and diversity 10of . Use an Arrow butto - n (or + ) to select the IMAGE LOCK icon
the dot pattern varies with then press the OSD Enter button to access the function.
the screen resolution.
If the screen flickers,11 . Using an Arrow button- or + ( ), seleAUctTO MATIC and press the
repeat the setup several
times until the flicker is OSD Enter button . This actiAvUTatOe SsET the UP procedure, which
minimised, or adjust it manually will optimize the display settings with the provided dot-patterns.
by following Manual Setu p
on page 13.The screen will dim, blink on and off several times and you may notice
small changes to the test pattern.
12. When finished, the OSD main menu returns. Press the Exit button
to exit from the OSD.
13. Press the ESCAPE key to exit the test pattern program.
14. Type?Ex it at ? the command prompt to return to Windows.
If you use other operating systems, perform the aAUTO SpprETUPop forirate
those systems, alsoAuto S: see etup for Windows 3.1, Windows 95, Win-
dows 98 or Windows NT on page 9 andAuto S etup OS/2 on page 11.
8 |
ACEC
