ENGLISH
Auto Setup for Windows 3.1, Windows 95, Windows 98 or Windows NT
If the monitor is in st1.andby Turn on the monitor first; then the PC.
mode (STANDBY ON), it
may automatically turn off while If the message CHECK SIGNAL CABLE is displayed, or if nothing is
you are waiting for it to warm upd.i splayed check:
You can disable the Windows
that the video interface cable is connected properly.FRAN�AIS
energy saving feature by
clicking on tTAhe SRT button and the correct video adapter card is installed.
selecting SETTINGS, CONTROL the correct supported display mode is selected for your PC.
PANEL, DISPLAY, SCREEN SAVER .
2.Wait approximately 15 minutes, until the monitor warms up.
Make sure that tNEhe ERGY
SAVING FEATURES OF MONITOR 3.Drag the icon bar and tool bar, if they are displayed, to the bottom of the
check boxes are either empty, or
screen.
that the features are set to at
least 20 minutes.DEUTSCH
4.Insert the diskette labelled ?IBM Monitor Installation Disk? into the
diskette drive.
Your system may also have its
Power Saving utility enabled
5.Check the operating system installed on your PC and follow the
through the Bios Setup Utility.
Refer to your system manual for instructions from the table below.
directions on disabling that bios
option.
Operating
Step1Step2Step3Step4ESPANOL
System
Windows 3.1Open
SelectSelect
PROGRAM
Windows NT 3.5FILERUN
MANGERType
?A:\TESTPAT?
Windows 95
and press
Select ENTER
Windows 98Select RUNITALIANO
START
Windows NT 4.0
The size and diversity 6.of When the test pattern appears, press the OSD Enter button at the
the dot pattern varies with
bottom of the monitor to display the initial OSD menu.
the screen resolution.
Position the mouse point7.er Use an Arrow button- or ( + ) to selectIM thAGE Le OCK icon and
at the bottom center of the
press the OSD Enter button to access the function.JAPANESE
screen. This alAlowsUTO
SETUP to run properly8.Using an Arrow button- or + ( ), seleAUcTOt MATIC and press the OSD
Enter button . This activAUTatesO SET thUP pre ocedure, which will
optimize the display settings with the provided test pattern.
The screen will dim, blink on and off several times, and you may notice
small changes to the test pattern.
(To abort tAUThe O SETUP function, presEsSC the key.)
COMPL & WARR9.When finished, the OSD main menu returns. Press the Exit button
once to exit from the OSD.
9 |
ACEC
