ENGLISH
Manual Setup
Normally, you can complete the setup proceAUTdurO Se ETUusP , hingo wever,
if your screen image is still distorted AafterUTO SET yUPo oru p etrhe seform tup FRAN�AIS
diskette does not run on your systemMAN, peUAL SrETforUP.m
If the monitor is in st1.andby Have your computer and monitor turned on for at least 15 minutes until
mode (STANDBY ON), it
the monitor and video adapter have warmed up.
might automatically turn off
while you are waiting for it to
2.You may wish to start the program you most often use so that you can
warm up.
adjust for a ?typical? screen.
DEUTSCH
To disable the Windows energy
3.Press the OSD Enter button at the bottom of the monitor to display
saving feature by clicking on the
START button and selecting the initial OSD menu.
SETTINGS, CONTROL PANEL,
4.Use an Arrow butto- orn ( + ) to select the IMAGE LOCK icon and
DISPLAY, SCREEN SAVER . Make
sure that tNEheRG EY SAVING press the OSD Enter button to access the function.
FEATURES OF MONITOR check
boxes are either empty, or 5.that Using an Arrow button- or + ( ), seleMActNU AL , press and then
ESPANOL
the features are set to at least 20 press once to sCOeleARSEct . Left and right arrow adjustment
minutes.
indicators become illuminated (see p). age 17
Your system may also have its
6.Use the Arrow buttons to correct (as much as possible) for noise in the
Power Saving utility enabled
video signal then press to save the changes.
through the Bios Setup Utility.
Refer to your system manual for
7.Use an Arrow button toFINE sele acnd pt ress the button.
directions on disabling that bios
option.8.Use the Arrow buttons again to tune the image to your liITALIANOking.
9.When finished, press the Exit button four times to exit from the OSD.
You have completed the monitor setup.
JAPANESE
COMPL & WARR
13 |
ACEC
