Power Managernment Setup 5DHX
PM Control by APM
This feature is automatically set to ?Yes?, the system BIOS will wait for APM
prompt before it enters the GREEN mode.
NOTE : If APM is installed, & if there is a task running, event the timer is time out, the APM
will not prompt the BIOS to put the system into any power saving mode!
Video Off Method
There are three options you can choose to turn off the VGA display.
Blank Screen- The system will blank the screen only.
DPMS- This function is enabled for only the VGA card supporting
DPM.
V/H SYNC + Blank- Choose this mode if your system use the monitor with
power management feature. In addition to the blank screen,
the system will turn off the horizontal and vertical sync
signal. Most monitor will turn off itself if these signal are
inactive.
Modem Use IRQ
If you installed the MODEM on your system, you can use this option to specify the
MODEM use which IRQ. Normally, if you install the external modem on COM1 will
use IRQ4 and COM2 will use IRQ3.
Doze Mode/Standby Mode/ Suspend Mode
These option specify the continuous idle time before the system enter the power
saving mode. Normally, Doze and Standby mode puts the system into low speed
clock and suspend mode puts the system clock stopped.
HDD Power Down
This option defines the continuous HDD idle time before the HDD entering power
saving mode (motor off).
Wake up & Resume Events
Page 19 |
ACEC
