Duet Manual Page 9 Tuesday, October 1, 2002 9:36 PM
Working It Connecting External Speakers
Connecting External Speakers
The following pages illustrate how to connect your Duoverb to Line 6 speaker cabinets.
If you are using any other cabinets be sure to check your speaker cabinetsO impedance
2Y 9
and choose the matching setting on your DuoverbOs rear panel impedance switch. In
correct settings will give you less volume than youOd expect, or cause Duoverb to
shutdown its power amps after a while to protect them from overheatingNif you are
uncertain about the settings to use with your setup, please consult an expert.
Hooking up your Combo in stereo to a single Duoverb 2x12 Cabinet
SPEAKER OUTS / CLASS 2 WIRINGOUTPUTCABINET
IMPEDANCEMODELING
4 OHMS8 OHMSOFF OPENCLOSED
RIGHTRIGHTLEFT- MONO -LEFT
Connect the speakers
from your combo to
the right outputs.
RIGHTLEFT
N222
STEREO - 8 MONO - 4
USE BOTH JACKSTHIS JACK ONLY
80 WATTS MAX PER SPEAKER160 WATTS TOTAL MONO
Hooking up your HD in stereo to a single closed back 2x12 cabinet
*If you are using an openSPEAKER OUTS / CLASS 2 WIRINGOUTPUTCABINET
IMPEDANCEMODELING
back cabinet such as the
Duoverb Extension
Cabinet select OPEN4 OHMS8 OHMSOFF OPENCLOSED
RIGHTRIGHTLEFT- MONO -LEFT
CABINET MODELING.
*
RIGHTLEFT
N222
STEREO - 8 MONO - 4
USE BOTH JACKSTHIS JACK ONLY
80 WATTS MAX PER SPEAKER160 WATTS TOTAL MONO |
ACEC
