Working It Y Quick Start Guide
WORKING IT
2Y 1
In a rush? Well, then, just read this page and come back to the rest later:
Quick Start Guide
POWER: Connect the power cord from Flextone IIIOs rear panel to your power outlet.
But donOt turn the power on yet.
PLUG IN: Jack your guitar into Flextone IIIOs INPUT. Turn Flextone IIIOs MASTER
knob (on the far right) all the way down. Locate Flextone IIIOs POWER switch on the
back by the power cord, and fire that bad boy up. Spin MASTER up to 9 oOclock or so.
Get ready for tasty tones...
MODELS KNOB: Spin this to select from the 16 amp flavors, each with two
variations, for 32 Amp Models total.
DRIVE, BASS, MID, TREBLE, PRESENCE, VOLUME KNOBS: What you see is
what you get hereNturn knobs Otil things sound good!
DELAY: Press the button to the left of the Delay knob to pick one of the Delay effects.
Tap in a tempo for the delay, and turn the Delay knob to get more or less of the effect.
MOD: Press the button to the left of the Mod knob to pick one of the Mod effects.
Turn the Mod knob to speed up or slow down the selected effect.
COMP/GATE: Press COMP and/or GATE to engage each effect. The Compressor
will smooth out your dynamics and add sustain. The Gate will mute the inherent noise
common to high gain amp tones when youOre not playing.
CHANNEL MEMORIES: These are like the buttons on a car radio that remember
your favorite stations. Press A, B, C or D to recall one of the 4 Channel Memories.
Press that button again to get back to Omanual mode.� YouOre in manual mode if none
of the A, B, C, or D buttons are lit. And just like a car radio, hold any of the buttons for
3 seconds to save your current settings to that memory for later recall. |
ACEC
