D. This section backs on to Section
A; it is 1 mm wider, to allow for fold
Color profile: _DEFAULT.CCM - Generic Profile
Composite Default screen
FOLDFOLD
page 2page 3page 4Eurotel 1500
Installation
Fit the belt clip onto the handsetAfter about 7 hours, when the batteries are
�I
Finding the best position for the base unit(this step is optional)Click the belt clip intofully charged, lift the handset
position, making sure it
To use your handset and base unit together, you must be able to
is securely fitted
establish a radio link between them. Be aware that:
nOther electrical equipment operating near your Eurotel 1500
may cause interference ? keep both the base unit and the handset
Stay near to the base unit
away from other telephones, fridges, washing machines,
microwave ovens, televisions, fluorescent lights, etc.
Press the button
�
nThe base unit must never be installed near a bath or shower, or
Hold it down for about 2 seconds, until the
anywhere else where it might get wet.Align the ridge on
display goes blank
the inside of the belt
nSiting the base unit as high as possible will give better results. In
clip with the grooveRelease the button then briefly press it again
a two-storey house, the best position for your base unit may be on
on the side of the
the first-floor landing.
handset, and fit the
For a few moments, the
nAny large metal object (e.g. a refrigerator, mirror or filingbelt clip to one side
display flashes ?
cabinet) may block the radio signal.of the handset
nOther solid structures, like walls, may reduce the signal strength.The flashing symbols mean
that your handset is
searching for a base unit
E
Remove the cover from theThe display then shows
back of the base unit
Place the handset on the base unit
Plug in the telephone�
line cord and the
BEEP
mains power lead
For details of other symbols and messages which might
Replace the cover
appear on the display, refer to page 2 of the User Guide
�
Insert the telephone line
plug into the socket
?Out of range? warning
The CHARGE light
If you are moving around while using your handset, and
240 V AC, 50 Hzcomes on.
you hear a warning tone, this means you are going out of
When the handset?s
range of the base unit.
batteries are fully
charged (after aboutMove closer to the base unit, until the tone stops
7 hours), the light
If you do not move, your call may be cut off,
flashes.
and you may have to wait up to 30 seconds
before you can use your handset again.
I
Plug in the mains
adapter, with the switch on
the mains socket set to OFFMakesuremainspowerisswitchedThe Eurotel 1500 must be used with mains adapter, part no. XX002094D, supplied
onifyouwanttousethephone?with the unit. Using any other adapter will result in non-compliance with EN41003,
Then switch on mains power
itwillnotworkwithoutitand will invalidate any approval given to this apparatus.
at the socket
E:...\QUICKREF\E1500qr2.cdr
08 September 1998 14:40:34
FOLDFOLD |
ACEC
