Key Frame Effect Timeline Status Display � 610
1Select the channel or channels to which the setting is to apply.
2Stop the effect at the desired pause position.
3Press F3 (PAUSE), turning it on.
This sets the pause.
Clearing the pause setting
Stop the effect at the currently set pause position, and press F3
(PAUSE), turning it off.
To move the current time to a pause position
Use the following procedure.
1Select the desired channel.
2YTo move the current time to the immediately preceding pause
position, hold down the SHIFT button and press the PREV
KF button.
Y To move the current time to the immediately following pause
position, hold down the SHIFT button and press the NEXT
KF button.
Setting a delay � F4 (DELAY)
This sets a delay from the time at which you carry out the effect
execution operation to the time at which the execution actually
starts.
1Select the channel or channels to which the setting is to apply.
2Press F4 (DELAY), turning it on.
3Enter the delay value (seconds.frames) from the numeric
keypad, and press the ENTER button.
This sets the entered value as the delay.
9-10Chapter 9 Status Displays |
ACEC
