SONY CRX140E User Guide

$4.99

SONY CRX140E - It's a complete user guide ( also known as operating manual owner's manual), and it's in PDF format. After placing order we'll send You download instructions on Your email. See below for delivery information

The manual is available only in language(s): English

Link to manual will be sent on Your email address after You place order.

This product was added to our catalog on Monday 07 May, 2007.

Reviews

Write Review

Buy & Download

Product Reviews

There are currently no reviews for this product.

Other reviews

Glen Meyer - 10/26/2008

Very fast service, manual is well scanned and clear, but the Appendix A containing PC Command table and Control codes are missing

John Craig - 07/31/2006

Very nice site and the manual is great. A life-saver. Thank you so much!

Jim Carrier - 08/02/2006

Outstanding and fast service! I received service manual in a moment after order. Thanks to this manual I can use my printer again!

Ernst-Guenter Hoffmann - 11/16/2007

Many thanks for the fast and easy delivery. When looking for a manual next time you will be my number one. Ernst, from good old Germany

Peter Rawson - 08/02/2006

Wow! I thought I wouldn't be able to find manual for such rare equipment like KM2000E. And here it is! Thanks for fast service!

Customers who bought this product also purchased

SONY 1401 Service Manual	SONY 710BK-AL Service Manual	SONY 5F-94L Service Manual
SONY 16180026 Service Manual	SONY 14DK1 Service Manual	SONY 6R-33 Service Manual

Click to see text excerpt from the manual

The drive comes pre-configured as an IDE Master device as7. Install the drive.
shown below with the Master pin jumpered.
To install the drive, position the drive in the drive bay
C SM391so that the screw holes of the drive are aligned with the
AudioMaster Pin
0 0R G G LS L A402+5 G G +12
OutputJumperedIDE ATAPIDC Power screw holes in the drive bay. Then tighten the screws
40-pin Connector
Connector
until they are firm. Do not over tighten the screws.
Slave pin (open)Pin 1
If the drive is the only drive on the EIDE port then the drive
should be the master drive. To make the Drive the master drive
you put the jumper block on the Master pin position
Cable Select
Slave
Master
DIGITAL
AUDIO ANALOGAUDIOSLAVECABLE SELECT
0 0MASTERHOST INTERFACE
R G G LCSM
SLA39
40
1POWER
2+5 G G +12
If the drive will be using the same port with a hard drive, then
the hard drive should be set as the master and the drive as the
slave drive. To make the drive the slave drive you put the
jumper block on the Slave pin position.
Slave
Master
Cable Select
20CD-RW Recorder UserOs GuideCD-RW Recorder UserOs Guide21