Setup Relating to Input/Output Signals (INPUT/OUTPUT Menu)
2Carry out the operation in the following table to make the required
setting.
SettingOperation
Output signal selectionUse the following procedure.
1Press F1 (OUTPUT SELECT), and move the cursor
to select the output signal group from SWER CLEAN
(switcher clean output), and DMK CLEAN (DMK-
7000 clean output). (The list of output signals
changes according to the selection.)
2Press F5 (SIGNAL SELECT), and move the cursor to
select the output signal from the list.
3Press F3 (SELECT), to confirm the selection of the
output signal.
Switching the previewUse the following procedure.
output for a switcher M/E1Press F7 (PVW OUT SELECT), and move the cursor
bank or DSK 1 to 4to select the PVW output, to which the subsequent
setting applies, from among M/E-1 to M/E-3 and
DSK1 to DSK4.
2Press F8 (PVW/KEY).
This cycles the setting through PVW, KEY, and
CLEAN for the M/E, or toggles between PVW and
KEY for the DSK.
Defining the PVW outputUse the following procedure.
of a switcher1Press F7 (PVW OUT SELECT), and move the cursor
to select the PVW output, to which the subsequent
setting applies, from among M/E-1 to M/E-3 and
DSK1 to DSK4.
2Press F9 (DEFINE PVW).
This toggles between L-PVW and K-PVW for the
M/E, or cycles the setting through L-PVW, K-PVW,
and F-PVW for the DSK.
Setting the auto cleanPress F2 (AUTO CLEAN) to toggle between ENBL
functionand DSBL.
ENBL: The auto clean function is enabled.
DSBL: The auto clean function is disabled.
Auto preview settingPress F4 (AUTO PVW), to toggle between OENBL� and
ODSBL�.
ENBL: The auto preview function is enabled.
DSBL: The auto preview function is disabled.
Setting the auto previewPress F10 (AUTO PVW2) to toggle between ENBL
2 functionand DSBL.
ENBL: The auto preview 2 function is enabled.
DSBL: The auto preview 2 function is disabled.
14-42Chapter 14Setup |
ACEC
