36
Cleaning and maintenance
ature is above 0!C. When you use the machine again, make sure that the ambient temper-ice forming and consequently damage to the appliance. By doing this, any water remaining in the machine is removed, avoidingYScrew the water inlet hose back on and put the drain hose back in itsYRemove the plug from the power socket. YPress the ON/OFF button to switch the machine off. YTurn the programme selector dial to RESET (KORREKTUR).YSelect the OPUMP OUT� programme (PUMPEN) and run it until theYPlace the end of the drain hose and the inlet hose in a bowl placedYClose the water tap and unscrew the water inlet hose from the tap.below 0!C, proceed as follows: If the machine is installed in a place where the temperature could dropFrost precautionsAt the end screw the filter again.out slowly. the drain filter after placing a bowl on the floor to let the water come example the appliance is built in the kitchen furniture, slightly loosen Should it not be possible to have access to the drain hose because, forYput the drain hose end into the bowl and let the water out.Yplace a bowl on the floor;Yif necessary, wait until the water has cooled;Yclose the water tap; Ypull out the plug from the power socket; clogged), proceed as follows to empty out the machine: If the water is not discharged (pump is blocked, filter or drain hose areEmergency emptying out
place.machine stops.on the floor.
TroubleshootingSomething not working?
tact your local AEGService Force Centre. to restart the programme. If after all checks, the problem persists, con- Once the problem has been eliminated, press the START/PAUSE button---During machine operation the following alarm codes may be displayed:even if requested within the guarantee period. or to repair a fault due to incorrect use, the call-out will be charged If you call out an engineer when one of the following problems arises,instructions below. If a problem arises, you can try to solve it yourself following themachines. machines that use less water than traditional the modern technology of new washing If water is not visible in the drum, this is due tomotor. tional washing machines, this is due to a new type of whistling noise, different from the noise made by tradi- If during the spin cycle the machine makes an unusual
The machine does not work
E20:E10:E00:
Problem
door openproblem with water drainingproblem with the water supply
option has been selected.the display. The DELAY STARTCheck the selected delay onbeen pressed. The START The plug is not connected.Insert the plug.closed The door is not properlyClose the door; the clickhas blown. The main electrical fuseReplace the fuse.has not been depressed. The ON/OFF buttonDepress the button.
Possible cause
(E20)
button has notPr
.of the lock should be heard.
ess the button.
Solution
37 |
ACEC
