INSTALLATION
TECHNICAL INSTRUCTIONS FORwith the external perimeter of the hob.
The ends of the strip must fit together without
THE INSTALLERoverlapping.
Installation may only be carried out by a- Stick the seal to the hotplate uniformly, pressing
competent technician or electrician.it with fingers.
- Take the protective paper strip of the seal off,
place the hotplate in the opening made in the
3) INSERTING
After having cleared out all the packingtable top, and lock it with the special screws
components, make sure of the integrity of the?F?(fig. 12).
appliance.
Please keep children away from all packingWARNINGS:
materials (carton, polystyrene, nails,..).Be aware that the glue joining laminated plastic to
Make a cutout in the worktop, according to thethe wood, has to resist to temperatures above
150° C, to avoid delamination.
dimensions indicated in fig. 7-8; make sure the
critical dimensions of the space in which theThe installer should bear in mind that the mixed
appliance has to be installed (fig. 9) are respected.appliance is the Y type. The rear wall, adjacent
and surrounding surfaces must therefore be able
to withstand temperatures above 65° C.
4) FIXING
A special sealing strip underneath the hob must be
used.
Make sure it is correctly positioned with no gaps to
avoid any water infiltration. To fit the strip in theCOMPLY WITH THE
right way, please, respect the following
instructions:
DIMENSIONS (mm)
- Fix the hooks in the relative accomodations of the body.
- Turn the hob over, take the seal strips off from
their support, taking care that the transparentABCDE
protection remains attached to the seal. Correctly2 ELEM.28548557.557.5 100 min.
place the seal ?E? (fig. 11) under the hob edge,
4 ELEM.56049057.557.5 100 min.
so that the external side of the seal fits together
FIG. 7FIG. 8FIG. 9
FIG. 10FIG. 11FIG. 12
7 |
ACEC
